Double And Abrasive Belt Grinders

Amber manufactures Double End Abrasive Belt Grinders which accommodates a direct drive motor and serrated contact rubber wheels at both the ends of the motor and the attachments for mounting, tensioning and resting the belt are mounted on the motor side cover. The belt tensioning arm can be tilted easily from 0 to 90 degrees as per the application. A rotary ON – OFF Switch is mounted on the motor base. A fabricated or Cast Iron pedestal stand can be provided on special request. Belt tensioning can easily be done by just pulling down the handle which is loaded on a spring.

A belt adjusting knob helps to easily adjust the belt on the wheel. A serrated contact rubber wheel behind the abrasive belt helps to effortlessly ground and finish castings, forgings, hardware, kitchenware, metal fabricated parts, plastic parts, glass edges, etc. Other than standard double end belt grinders Amber can also manufacture customized belt grinders suitable for any particular application.

• HP : 2 to 5,
• Phase : 3
• Voltage :415 V
• Frequency : 50 Hz
• RPM : 3000
• Abrasive Belt Size : 2000 X 50 & 3500 X 50mm
• Contact Wheels : 8, 10, 14 & 16 Inches